Notes on Reading This Manual
(1) This manual explains general parameters as viewed from the NC. For information about each machine tool,
refer to manuals issued from the machine tool builder. If the descriptions relating to "restrictions" and
"allowable conditions" conflict between this manual and the machine tool builder's instruction manual, the later
has priority over the former.
(2) This manual is intended to contain as much descriptions as possible even about special operations. The
operations to which no reference is made in this manual should be considered impossible.
(3) The "special display unit" explained in this manual is the display unit incorporated by the machine tool builder,
and is not the MITSUBISHI standard display unit.
(4) This manual is for the machine tool builders who set up the NC system.
嵌入型I/O模块 AJ65MBTL1N-32D
PLC FX2N-128MT-D
PLC FX1N-40MT-DSS
PLC FX1N-40MT-ES/UL
伺服放大器 MR-J3-200B
存储器盒 FX3U-FLROM-64
编码器电缆 MR-JCCBL20M-H
PLC FX3U-32MT/ES-A
存储卡 FX-RAM-8
伺服放大器 MR-J2S-70B
伺服电机 HC-MFS73B
伺服放大器 MR-J2S-11KA4
PLC FX2N-48MT-001
编码器接头 MR-J3JCBL03M-A1-L
伺服马达 HA-LFA701M4B
PLC FX2N-16MT-001
PLC FX1N-24MR-D
对应SSCNET定位模块 QD75M2
PLC FX2N-16MR-D
接线端子块电缆 MR-J2TBL1M
编码器用电缆 MR-EKCBL30M-H
编码器接头 MR-J3JCBL03M-A2-L
伺服放大器 MR-J3-500A
伺服马达 HF-MP43
SSCNET Ⅲ 光纤 MR-J3BUS30M-B
Q系列PLC存储卡 Q3MEM-8MBS-SET
编码器接头 MR-J3ENSCBL2M-H
伺服驱动器 MR-J2S-60A
PLC FX3U-32MR/ES-A
编码器接头 MR-J3ENCBL10M-A2-H