(Always read these instructions before using the equipment.)
Do not attempt to install, operate, maintain or inspect the units until you have read through this Instruction
Manual, Installation Guide, Servo Motor Instruction Manual and appended documents carefully and can use
the equipment properly. Do not use the units until you have a full knowledge of the equipment, safety
information and instructions.
In this Instruction Manual, the safety instruction levels are classified into "WARNING" and "CAUTION".
WARNING Indicates that incorrect handling may cause hazardous conditions,
resulting in death or severe injury.
CAUTION Indicates that incorrect handling may cause hazardous conditions,
resulting in medium or slight injury to personnel or may cause physical
damage.
Note that the CAUTION level may lead to a serious consequence according to conditions. Please follow the
instructions of both levels because they are important to personnel safety.
What must not be done and what must be done are indicated by the following diagrammatic symbols:
: Indicates what must not be done. For example, "No Fire" is indicated by

.
: Indicates what must be done. For example, grounding is indicated by

.
In this Instruction Manual, instructions at a lower level than the above, instructions for other functions, and so
on are classified into "POINT".
After reading this Instruction Manual, always keep it accessible to the operator.
伺服放大器 MR-J2S-70A
伺服控制器 MR-J2S-700A
伺服驱动器 MR-J2S-40B
伺服放大器 MR-J2S-100B4
伺服驱动器 MR-J2S-37KA4
伺服控制器 MR-J2S-11KB4
伺服驱动器 MR-J2S-10A
伺服驱动器 MR-J2S-60B
伺服放大器 MR-J2S-200B4
伺服控制器 MR-J2S-30KA
伺服驱动器 MR-J2S-15KB4
接线端子块电缆 MR-J2TBL05M
CON2接头 MR-J2CMP2
伺服控制器 MR-J2S-37KA
CC-Link接口单元 MR-J2S-T01
伺服驱动器 MR-J2S-22KB4
伺服驱动器 MR-J2S-10B
控制器放大器总线电缆 MR-J2CN1-A
控制器放大器总线电缆 MR-J2HBUS5M-A
附件 MR-J2HBUS05M
伺服放大器 MR-J2S-350B4
伺服控制器 MR-J2S-500A
控制器放大器总线电缆 MR-J2HBUS05M-A
伺服放大器 MR-J2S-70B
伺服放大器 MR-J2S-200B
伺服放大器 MR-J2S-700A4
伺服控制器 MR-J2S-22KA4
编码器接头 MR-J2CNM
伺服控制器 MR-J2S-700B
伺服控制器 MR-J2S-15KA4