*4 Connect the ground terminal on the FX-2DA with
the ground terminal on the base unit of the
programmable controller. Use class 3 grounding
on the base unit, if available.
1 Use a twisted pair shielded cable for the analog
output. This cable should be wired away from
power lines or any other lines which could induce
noise.
Caution;
(a) The same output channel cannot drive current
and voltage output loads at the same time!
(b) Shorting the voltage output terminals may da-
mage the unit!
2 Apply 1-point grounding at the load side of the
output cable (class 3 grounding: 100 Ω or less). If
electrical noise is caused from grounding,
disconnect from grounding.
3 If electrical noise or a voltage ripple exists at the
output, connect a smoothing capacitor of 0.1 to
0.47 µF, 25V.
终端模块 FX-16EYT-H-TB
输入输出电缆 FX-A32E-300CAB
连接电缆 FX-232CAB-2
RS-232C/RS-422转换器 FX-232AWC-H
输入输出电缆 FX-A32E-500CAB
存储卡 FX-EEPROM-4
输入输出电缆 FX-A32E-150CAB
存储卡 FX-EEPROM-16
RS-422/USB转换器 FX-USB-AW
终端模块 FX-16EX-A1-TB
通用的输入输出电缆 FX-16E-500CAB-S
终端模块 FX-32E-TB
终端模块用的输入输出电缆 FX-16E-500CAB-R
终端模块 FX-16EYS-TB
终端模块用的输入输出电缆 FX-16E-300CAB-R
存储卡 FX-RAM-8
终端模块用的输入输出电缆 FX-16E-500CAB
终端模块用的输入输出电缆 FX-16E-150CAB-R
终端模块 FX-16E-TB
存储卡 FX-EEPROM-8
终端模块 FX-16EYT-TB
RS-422电缆 FX-422CAB0
连接电缆 FX-232CAB-1
终端模块用的输入输出电缆 FX-16E-150CAB
终端模块用的输入输出电缆 FX-16E-300CAB
存储卡 FX-EPROM-8
终端模块 FX-16EYR-TB