1. To prevent electric shock, note the following
WARNING
Before wiring or inspection, turn off the power and wait for 15 minutes or more until the charge lamp turns
off. Then, confirm that the voltage between P( ) and N( ) is safe with a voltage tester and others.
Otherwise, an electric shock may occur. In addition, always confirm from the front of the servo amplifier,
whether the charge lamp is off or not.
Connect the servo amplifier and linear servo motor to ground.
Any person who is involved in wiring and inspection should be fully competent to do the work.
Do not attempt to wire the servo amplifier and linear servo motor until they have been installed. Otherwise,
you may get an electric shock.
Operate the switches with dry hand to prevent an electric shock.
The cables should not be damaged, stressed, loaded, or pinched. Otherwise, you may get an electric shock.
During power-on or operation, do not open the front cover of the servo amplifier. You may get an electric
shock.
Do not operate the servo amplifier with the front cover removed. High-voltage terminals and charging area
are exposed and you may get an electric shock.
Except for wiring or periodic inspection, do not remove the front cover even of the servo amplifier if the
power is off. The servo amplifier is charged and you may get an electric shock.

2. To prevent fire, note the following
CAUTION
Install the servo amplifier, servo motor and regenerative resistor on incombustible material. Installing them
伺服马达 HA-LFS6014
背光灯 GT15-90XLTT
编码器接头 MR-J3ENCBL5M-A1-H
RS-485端子台转换电缆 FA-LTBGTR4CBL20
存储器盒 FX3U-FLROM-64
GT15人机界面 GT1550-QLBD
交流电抗器 FR-HAL-H185K
伺服马达 HA-LFS801
编码器电缆 MR-JHSCBL2M-L
伺服马达 HA-LFS701M
PLC FX2NC-96MT-D/UL
PLC FX1N-40MT-ES/UL
电磁制动器用电缆 MR-BKS2CBL03M-A2-L
大型扩展基板 Q55BL
Melsecnet模块 A1SJ71LP21
GT10触摸屏 GT1020-LBD
编码器接头 MR-J3ENCBL10M-A2-H
直流电抗器 FR-HEL-H15K
GT10触摸屏 GT1020-LWL
GT11触摸屏 GT1150-QLBD
SI/QSI光缆型模块 QJ72LP25-25
直流电抗器 FR-HEL-H18.5K
交流电抗器 FR-HAL-H37K
伺服电机电源用电缆 MR-PWS1CBL10M-A2-L
伺服电机电源用电缆 MR-PWS1CBL10M-A1-L
编码器电缆 MR-JCCBL20M-H
编码器接头 MR-J3ENCBL5M-A2-L
总线连接单元 GT15-75ABUS2L
MELSEC-I/O LINK主站模块 FX2N-16LNK-M
伺服马达 HA-LFS11K24B