WARNING
. Items related to operation
If the operation start position is set in a block which is in the middle of the program and the
program is started, the program before the set block is not executed. Please confirm that G
and F modal and coordinate values are appropriate. If there are coordinate system shift
commands or M, S, T and B commands before the block set as the start position, carry out
the required commands using the MDI, etc. If the program is run from the set block without
carrying out these operations, there is a danger of interference with the machine or of
machine operation at an unexpected speed, which may result in breakage of tools or
machine tool or may cause damage to the operators.

Under the constant surface speed control (during G96 modal), if the axis targeted for the
constant surface speed control moves toward the spindle center, the spindle rotation
speed will increase and may exceed the allowable speed of the workpiece or chuck, etc. In
this case, the workpiece, etc. may jump out during machining, which may result in
breakage of tools or machine tool or may cause damage to the operators.
电磁制动器用电缆 MR-BKS1CBL10M-A1-L
RGB输出单元 GT16M-ROUT
GT16触摸屏 GT1665M-STBA
PLC FX1S-30MT-DSS
编码器电缆 MR-ENCBL5M-H
PLC FX3U-64MR/DS
PLC FX1N-24MR-ES/UL
伺服放大器 MR-J3-100A
Q系列编程器ATA卡 Q2MEM-8MBA
伺服电机 HC-MFS23
PLC FX2N-16MR-D
伺服放大器 MR-J3-40A
电磁制动器用电缆 MR-BKS1CBL2M-A1-L
电磁制动器用电缆 MR-BKS2CBL03M-A2-L
伺服放大器 MR-J3-20B
电磁制动器用电缆 MR-BKS1CBL5M-A2-H
显示模块 FX3U-7DM
PLC FX1N-40MR-ES/UL
定位控制模块 A1SD75M1
PLC FX1S-14MT-ES/UL
伺服控制器 MR-J2S-700A
对应SSCNET III定位模块 QD75MH1
PLC FX2N-64MR-DS
伺服控制器 MR-J2S-15KB
PLC FX2NC-32MT-DSS
伺服马达 HA-LFS11K1M4
PLC FX2N-16MT-DSS
编码器电缆 MR-JCCBL10M-L
PLC FX2N-80MT-ESS/UL
伺服电机 HC-MFS053